Peugeot 308 Key Fob Replacement

Peugeot's 308 might be getting on a bit, but it still feels attractive. It's not the most luxurious car in its class, but it's a relaxing and civilised drive.

Here at Coded Car Keys we are often asked to replace Peugeot Key Cutting 308 key fobs. The following tips can assist whether the issue is ongoing or intermittent.

Water Damage

If you leave your key fob in a puddle or get it wet while swimming, kayaking, canoeing, rafting or canyoning, it's likely to sustain water damage. The best way to stop this from happening is to keep it in a dry, dry bag when you're going outdoors or doing things where the fob might be exposed to excessive amounts of water.

It's also essential to make sure that the fob has dried out prior to opening it to use it again. If you smell any odors from the fob (such as industrial liquid or windshield washer fluid) It's another indicator that it is submerged.

A circuit board that is wet could cause the battery to lose its charge or even explode. If you are able to get your 308 keyfob out of the water it is best to turn the button side up and shake as much water as possible before opening the casing. When you've opened it, remove the battery, and then clean the circuit board using the help of a cotton swab that has been dipped in 90-percent isopropyl alcohol.

Other reasons your Peugeot 308 remote entry keyless system may not work include a dead coin-cell battery, receiver module problems signal interference, or a malfunctioning chip. If none of the above are the reason it is possible to reset the system by disconnecting 12 volt battery from your car for 15 minutes.

Dead Coin Battery

peugeot 2008 replacement key cars are equipped with a remote-start system which allows the driver to start the car from afar while warming up or cooling down the car prior to entering. This feature is extremely useful particularly in cold winter months. However, there are times when the remote start system stops working due to a variety of causes, such as the battery in the coin is dead.

The coin-shaped battery contained inside the key fob could last between two and four years based on how often it is utilized, the place it was purchased, and the way it is utilized. The date of use is usually printed on the package or written in the manual.

If the key fob is not functioning after exposure to water that is clean, you should remove the battery, clean the chip using a paper towel and isopropyl alcohol, then dry it completely before replacing it. If the key fob was exposed to soapy or salty water, it could have caused the chip to be damaged. It is necessary to replace it.

If you're unsure if the battery is faulty, you can test its voltage with a multimeter set to the vehicle's voltage range and connected to the minus and plus terminals. The voltage should be around 12-13 volts, but if it's lower, the battery needs to be replaced. Alternatively, you can try to reset the on-board computer by disconnecting the 12 volt battery for a couple of minutes, and reconnecting it in reverse order (positive cable first, then negative). The engine should begin to run after this.

Faulty Receiver Module

If you're not getting the "Key Detected" message on your dashboard, it's possible the receiver module has created a fault. It's the part that sends out an alert when the key fob goes off. It also acts as an alarm and prevents the car from starting if you don't have the correct key.

This could be due to a variety of causes including water damage or simply ageing. If the electronic chip in your Peugeot 308 keyfob has been damaged by dirty tap water it could be due to the fact that the keyfob was exposed to it. In this instance, you'll have to remove it and thoroughly clean it using isopropyl or an electronic cleaner. Once it's dry, you can put the battery back in and test it again.

If the problem persists it is a good idea to consult an area Peugeot expert or locksmith. They can use a diagnostic tool in order to identify the issue and repair it.

The loss of your Peugeot car keys could be a stressful experience. A certified auto locksmith can resolve the issue within minutes. They can program your vehicle and cut a new, working key for you. Find a locksmith near you.

Faulty electronic chip

The electronic chip inside your Peugeot 308 key fob is an crucial component of the remote control system. If it is damaged, your car might not start or you might receive a message stating "anti-theft active". If this happens, the only way to fix the issue is to purchase a new key. Luckily, auto locksmiths who are professionals can offer the service in the shortest time.

The chip in your peugeot 406 remote key programming 308's key fob could be damaged due to a variety of reasons, such as sweat, water damage or dirt. If your Peugeot key fob has been exposed to dirty or soapy water, it must be cleaned as soon as possible. You can use a paper towel and isopropyl ethanol to clean the electronic component. After that, let the battery dry completely.

Radio interference can cause a key fob to stop functioning. This is usually caused by other devices operate on the same frequencies as your Peugeot keyfob. It could be caused by unsafe conditions or objects that are within the vicinity of the vehicle. If you experience this problem it is advised to visit the Peugeot dealership.

The peugeot partner key replacement 207/308 Key Fob is very delicate and requires special care. It is essential not to drop or throw the key fob. If you lose it, try to locate it as quickly as possible. You can reset all the on-board computers by disconnecting the battery that is 12 volts for a short period of time. Remove the negative cable before the positive.